Walking Stick Forum banner

3" World Globe On Walking canes

1499 Views 3 Replies 3 Participants Last post by  CV3
Just applied the final coat of polyurethane to the two carved snake walking canes and one curled walking cane .

The 3" world globe paper weights will be mounted to the top of each cane.

Looking pretty good so far.

See less See more
1 - 4 of 4 Posts
Thats different from your norm nice one .I hope it creates more interest for your site.

Never seen a globe on one .was it difficult to drill out the hole for the rod?
Wasn't to bad.

The core of the globes was concrete, so I used a masonary drill and it went pretty well.

I epoxyed a bolt about 1 1/2" into the globe, which left about the same amount to epoxy into the stick.

They are different, but was what the customer asked for.

No scales on snakes either.
Nice job. They are different. I am sure the customer was happy. The problem I have with round top canes is they are difficult to manage.They always seem to fall over.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.