Walking Stick Forum banner
1 - 1 of 11 Posts

· Registered
3,081 Posts
I carve with palm and mallet tools but used a Dremel for a few years for clean up some shaping. I word recommend a Foredom flex shaft. They are a bit more but I have had the same one for 15 years. Just had to replace the shaft a few times. With a foot control you can ajust rpms from 0 to 18,000.
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.