Walking Stick Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
10 Posts
I had exactly the same problem. I thought of simply joining a short section to the bottom of the cane, using a threaded rod and epoxy. But it would probably be too noticeable, and would certainly create a weak spot, prone to breakage. In the end, I cut off the topper (like yours, it formed a "socket" for the stick) and drilled, gouged, and finally ground out the remnant of the shaft and adhesive, being very careful not to mar the surface of the topper. Then I attached it to a new shaft of appropriate length. It was a shame to waste a very attractive stick, but the thing was of no use as it was.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top