Walking Stick Forum banner

Rockler Cane hardware

2202 Views 5 Replies 4 Participants Last post by  Groomporter
I was playing with my lathe today and trying to make a two-part cane using the hardware that Rockler woodworking sells. http://www.rockler.com/brass-cane-hardware

Any tips on getting the hardware screwed into the pilot holes? They have non-standard threads so I was pretty much stuck using one side to screw the other side in place which meant they got stuck together. Maybe if I use something as a gasket like a "washer" cut out of cardboard, or rubber so they don't screw together as tightly?
1 - 1 of 6 Posts
  • Like
Reactions: 1
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top